eLaws | eCases | State of Nevada | Nevada Statutes | Nevada Administrative Code | Nevada Courts | Counties & Cities of Nevada | Code of Federal Regulations | United States Code |
 Clark County
 Code of Ordinances
 Title 30. UNIFIED DEVELOPMENT CODE
 Appendix 30.40. Zoning Base Districts

  § 30.40.250. Purpose of the M-2 Industrial District.  

Latest version.

  • The M-2 Industrial District is intended to provide areas suitable for the location and operation of the most intense manufacturing and industrial activities. See Table 30.56-2 (Design Standards) for additional design standards.

    Table 30.40-5 Industrial Districts - Bulk, Yard and Space Regulations
    Property Development Standards M-D M-1 M-2
    1. Architectural intrusions and enclosures may intrude into a required setback up to three (3) feet, but shall not be less than three (3) feet to a property line.
    2. No structure other than a permitted fence, wall or accessory structures per 30.56.040(f) shall be located within 10 feet of a street. See 30.56.040(d) for possible additional restrictions.
    3. Property located within an overlay district regulated by Chapter 30.48 is subject to the additional standards and restrictions specified therein.
    Lot Coverage 80% 80% 80%
    Yard Setback
    Not including permitted or required fences and walls when set back for required landscaping. Setbacks are measured from property line or edge of private street, which ever is greater. In no case shall the minimum setback from a street be less than 10 feet. Also see Chapters 30.56, 30.44 (use-related), and Building Code for additional setbacks and separations.
    Front 20 feet 20 feet 20 feet
    Interior Side
    Only when adjacent to a non-industrial or non-commercial use; otherwise no setback required.     		20 feet 20 feet 20 feet
    Side Street (corner) 20 feet 20 feet 20 feet
    Rear
    Only when adjacent to a non-industrial or non-commercial use or street; otherwise no setback required.     		20 feet 1,2 20 feet 1,2 20 feet 1,2
    Height 50 feet 1,2 50 feet 1,2 75 feet 1,2
    Additional Requirements
    1. A height setback ratio per Figure 30.56-4 (Setbacks From Streets - Buildings Over 35 Feet). Buildings may not encroach into any Airport Airspace Overlay District Boundary.
    2. A height setback ratio per Section 30.56.070 (Height), Figure 30.56-10 (Height/Setback).

     

(Ord. 3354 § 5 (part), 2006; Ord. 3055 § 3 (part), 2004: Ord. 3008 § 5 (part), 2003; Ord. 2573 § 8 (part), 2001; Ord. 2510 § 9 (part), 2000; Ord. 2481 § 3 (part), 2000; Ord. No. 4481, § 8, 4-19-2017)